Hello everyone. In this article, we will try to send LL UART communication using interrupts. What is LL? If you are wondering what LL is, please refer to the article HAL and LL. The following is the development environment at the time of posting. PC: Windows 10 OS IDE: STM32CubeIDERead More →
Hello everyone. In this article, we will try to send communication by UART using LL with polling. What is LL? If you are wondering what LL is, please refer to the article HAL and LL. The following is the development environment at the time of posting. PC: Windows 10 OSRead More →
Hello everyone. I’m going to start using LL to communicate via UART. The following is the development environment at the time of submission. PC: Windows 10 OS IDE: STM32CubeIDE Version1.5.0 Configurator: STM32CubeMX Version6.1.0 Board: STM32Nucleo-F401RE Create a project Start the IDE, select File- New – STM32 Project, when the TargetRead More →
Hello everyone. This time, I’ll try to output the GPIO initialization code for each HAL and LL in the IDE. Here is the development environment at the time of posting. (I have upgraded the development environment of CubeIDE and CubeMX as follows) PC: Windows 10 OS IDE: STM32CubeIDE Version1.5.0 Configurator:Read More →
Hello everyone. This time I will talk about LL, which is contrasted with HAL. For STM32 HAL: For Hardware Abstraction Layer LL: Low Layer exists. HAL was created to maintain compatibility with the STM32 series and reduce the amount of code written by the user. Therefore, HAL has disadvantages suchRead More →